Before you start
Before you begin, make sure:
The charging station is physically installed and powered on
The iEnergyCharge app is installed on your device
The charging station is updated to the latest software version
Step-by-Step Instructions
1. Connect the charging station to the network
Connect an Ethernet cable to the Ethernet port on the charging station
Verify the connection is established by checking the iEnergyCharge app
For network infrastructure requirements and troubleshooting, see Infrastructure requirements for the gateway.
2. Plug&Play discovery and configuration
This charging station supports Plug&Play, requiring no manual configuration. It is automatically detected during gateway commissioning and configured with the appropriate settings.
3. Discover the charging station in the commissioning wizard
The charging station is now ready for the commissioning wizard. The gateway will scan the network to find available devices, which may take a few minutes. Once complete, the charging station will appear on the results page.
FAQ
Why isn't the charging station appearing in the commissioning wizard?
Check that the charging station is connected via Ethernet and that the connection is confirmed in the iEnergyCharge app. Restart the gateway and wait for the network scan to complete.
How do I update the firmware of the charging station?
You can perform the update through the iEnergyCharge app. For detailed update instructions, refer to the official Sungrow documentation.
Supported models
AC22E-01